My intermediate shaft mount only has two holes in it (see picture 1). The two holes do not line up with the holes on the ZE block (see picture 2 & 3). As you can see the mount has room for a third hole but the hole is not present. It appears if I drill the third hole it may line up with a tap on the block but it may not.

I currently have it mounted with only one bolt. I am actively seeking info about this problem….maybe I can order the entire assembly with the proper mount….any idea’s.

I know it’s not good to run with only one bolt but I am not pounding the car at the moment and when I removed the mount one bolt was very loose so temporarily it will be no different than before.

Did anyone else have this problem? AND yes this is a true KLZE the head has 31-101 on it and the cams have KL-31 on them.